Hello Guest it is November 18, 2019, 02:07:13 PM

Author Topic: Anyone running a CNCshark with Mach3?  (Read 2079 times)

0 Members and 1 Guest are viewing this topic.

Offline Greolt

*
  •  956 956
    • View Profile
Anyone running a CNCshark with Mach3?
« on: June 04, 2010, 06:39:13 AM »
Anyone running a CNCshark with Mach3?

I believe it is using an NCpod which should be no problem to run with Mach.

Greg

Offline Tweakie.CNC

*
  • *
  •  8,002 8,002
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Anyone running a CNCshark with Mach3?
« Reply #1 on: June 04, 2010, 08:41:31 AM »
Hi Greg,

I thought the CNCshark was USB driven.
If you can you get access to the driver card for parallel connection then I think it would be possible to drive the machine from Mach3.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline Greolt

*
  •  956 956
    • View Profile
Re: Anyone running a CNCshark with Mach3?
« Reply #2 on: June 04, 2010, 08:53:48 AM »
Yes it is USB driven.

As far as I know it is using an NCpod.  Mach has a plugin for that.

In theory it should just be a matter of plug it in and go. I have used NCpod in the past.

Just wondered if any body was doing it.

Greg