Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Greolt on June 04, 2010, 06:39:13 AM
-
Anyone running a CNCshark with Mach3?
I believe it is using an NCpod which should be no problem to run with Mach.
Greg
-
Hi Greg,
I thought the CNCshark was USB driven.
If you can you get access to the driver card for parallel connection then I think it would be possible to drive the machine from Mach3.
Tweakie.
-
Yes it is USB driven.
As far as I know it is using an NCpod. Mach has a plugin for that.
In theory it should just be a matter of plug it in and go. I have used NCpod in the past.
Just wondered if any body was doing it.
Greg