Its an ORAC. I use the original vfd and step motors. Using Gecko 210 for them.
I got 5vdc connected to the breakout board and 12v to the C6-board. A relay to start/stop the spindle.
At ports and pins I have choose port 1; pins 6,7. Low active.
At the spindle setup I have set: port 1 to the relay, Motor control by step/Dir,
Output signals enabled pin1.
Just consentrated me on the spindle right now, taking it step by step.
Would like to be able to measure the 0-12v output on the C6. But I only get 0v
/Jim