Hello Guest it is May 22, 2025, 01:31:02 PM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: Speed and noise problem  (Read 19343 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Speed and noise problem
« Reply #20 on: February 21, 2010, 01:09:57 PM »
The code you attached is small, what size are you meaning it to be?
Hood
Logged

Offline furkan

*
  • 20 20
Re: Speed and noise problem
« Reply #21 on: February 21, 2010, 01:12:14 PM »
It must be bigger than 6 centimetres but I'm not sure because I didn't save the dxf file.
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Speed and noise problem
« Reply #22 on: February 21, 2010, 01:54:54 PM »
It sounds to me like you have forgotten to tell LazyCAM the units and it has assumed you were in inches.
Try doing some code with a wizard and make sure you choose its in mm if you  get the option.
Hood
Logged

Offline furkan

*
  • 20 20
Re: Speed and noise problem
« Reply #23 on: February 21, 2010, 02:08:55 PM »
Ok. So I think no problem with hardware but the codes. I'll try to create a correct code and try again.
Logged

Offline furkan

*
  • 20 20
Re: Speed and noise problem
« Reply #24 on: February 21, 2010, 02:09:26 PM »
thanks a lot.
Logged
Pages: « 1 2 3   Go Up
« previous next »