Hello Guest it is March 29, 2024, 01:13:19 AM

Author Topic: A Short Video.  (Read 5287 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
A Short Video.
« on: December 05, 2009, 11:59:32 AM »
Just a bit of fun really, but I decided to make a couple of short videos to put on my website. The hardest part was adjusting the feedrate so that the job took the same length of time as the musical score.
This one is a bit better than my first video but I think that more practice is needed.

                   http://www.tweakie.byethost.com/engrave1.wmv

Tweakie.
« Last Edit: May 31, 2018, 08:19:46 AM by Tweakie.CNC »
PEACE
Re: A Short Video.
« Reply #1 on: December 05, 2009, 05:24:15 PM »
I can't see the video, link does not work for me

Jeff

Offline Sam

*
  • *
  •  987 987
    • View Profile
    • hillbillyhilton.com
Re: A Short Video.
« Reply #2 on: December 05, 2009, 10:44:41 PM »
 ;D Good stuff Tweakie. Didn't know what it was till 1:00.
Jeff: right click the link, and save it to your computer. Then open it. It's in standard windows format, so there should be no problem if your using windows. It may not open correctly if you just click the link.
« Last Edit: December 05, 2009, 10:47:51 PM by Sam »
"CONFIDENCE: it's the feeling you experience before you fully understand the situation."

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: A Short Video.
« Reply #3 on: December 06, 2009, 04:13:57 AM »
You are way ahead of me Sam, I didn't know what it was until I was 10 Years old !!!.  ;D ;D

Tweakie.
« Last Edit: December 06, 2009, 12:03:12 PM by Tweakie.CNC »
PEACE

Offline BarryB

*
  •  267 267
    • View Profile
Re: A Short Video.
« Reply #4 on: December 06, 2009, 01:12:32 PM »
it took me the same time 1:00 that is.  Fun stuff.
Re: A Short Video.
« Reply #5 on: December 16, 2009, 04:58:37 PM »
Hi Tweekie,

What cutter type
What motor spinde speed
What cut depth
What material used.

 ;D ;D ;D ;D

Lots of questions from a newbie  ;D

By the way. Great dem, great music, great result

Len-Tik
One step at a time!

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: A Short Video.
« Reply #6 on: December 17, 2009, 03:28:37 AM »
Hi Len-Tik,

Cutter is a standard carbide engraving bit 30 degrees angle.
Spindle speed was 3000 rpm.
The cut depth was -0.2 mm.
And the material is Traffolite (a standard engraving laminate).

Glad you enjoyed the video - There is another one here http://www.flickr.com/photos/tweakie-cnc/4174280038/ this time it's a PCB.

Tweakie.
PEACE