Hello Guest it is March 28, 2024, 12:39:10 PM

Author Topic: 1-Port Parallel PCI Card  (Read 19605 times)

0 Members and 1 Guest are viewing this topic.

Re: 1-Port Parallel PCI Card
« Reply #10 on: November 29, 2009, 03:03:19 PM »
Okay I'm looking at the inputs section on ports and pins but I dont see X limit only x ++, x --, x home?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: 1-Port Parallel PCI Card
« Reply #11 on: November 29, 2009, 03:04:48 PM »
Any will do.
Hood
Re: 1-Port Parallel PCI Card
« Reply #12 on: November 29, 2009, 03:08:29 PM »
I have checked box for enable x home, port 1, pin 12, do i have to check active low or emulated?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: 1-Port Parallel PCI Card
« Reply #13 on: November 29, 2009, 03:16:25 PM »
You can check active low if you wish, that will mean the LED on the diagnostics will light when you short, if you leave it active high then it will go out when you short. Make sure you have it enabled but there is no need for the emulation.
Hood
Re: 1-Port Parallel PCI Card
« Reply #14 on: November 29, 2009, 03:20:51 PM »
okay when i dont check active low i cannot reset until i togle to active low (the program offers to do this for me). However I dont seem to get any response shorting out pin 12 to pin 25?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: 1-Port Parallel PCI Card
« Reply #15 on: November 29, 2009, 03:24:01 PM »
You dont need to worry about the reset, the LED should react even when Mach is in reset.
Hood
Re: 1-Port Parallel PCI Card
« Reply #16 on: November 29, 2009, 03:32:46 PM »
okay no joy with pin 12, however i have enabled the inputs to port 1 and can seem to switch leds on and off...
Re: 1-Port Parallel PCI Card
« Reply #17 on: November 29, 2009, 03:34:24 PM »
even though i haven't assigned any pin numbers?!

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: 1-Port Parallel PCI Card
« Reply #18 on: November 29, 2009, 03:38:03 PM »
Dont see how that could be possible, can you attach  a screenshot of what you have set and tell me which pins you are shorting to switch the LED.
Hood
Re: 1-Port Parallel PCI Card
« Reply #19 on: November 29, 2009, 03:41:56 PM »
Duh sorry this is all very new to me.. How do I take snapshot of screen and attach?