Is there anyone that is using the mach3 and Ajax cnc kit with the d3Io board that can give me
any good or bad thoughts

I'm Looking to retrofit my fryer MB15 mill with a milltronics control i have a burned axis drive that cost over a grand to
repair an no programmable spindle  that's about the same cost of the kit


thanks for your help and thoughts

Hi Adam,
  Ed has an Ajax set-up.
http://www.machsupport.com/forum/index.php/topic,13112.0.html
Give him a shout.
Russ

thanks Overloaded


Any One want to buy my old milltronics control

Good lookin bed mill you have there. I would definitley go for the Ajax setup.

Ed