Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Cncman2nv on November 14, 2009, 07:02:09 PM
-
Is there anyone that is using the mach3 and Ajax cnc kit with the d3Io board that can give me
any good or bad thoughts
I'm Looking to retrofit my fryer MB15 mill with a milltronics control i have a burned axis drive that cost over a grand to
repair an no programmable spindle that's about the same cost of the kit
thanks for your help and thoughts
-
Hi Adam,
Ed has an Ajax set-up.
http://www.machsupport.com/forum/index.php/topic,13112.0.html
Give him a shout.
Russ
-
thanks Overloaded
Any One want to buy my old milltronics control
-
Good lookin bed mill you have there. I would definitley go for the Ajax setup.
Ed