Hello Guest it is March 28, 2024, 02:47:08 PM

Author Topic: Is G84 supported in Mach3?  (Read 3737 times)

0 Members and 1 Guest are viewing this topic.

Is G84 supported in Mach3?
« on: October 07, 2009, 06:12:17 PM »
Yes I have used the search function and read all of the posts I found and I have searched the MachMill manual and noticed the G84 section is greyed out.  So my question is Mach capable of rigid tapping if the mill is capable?
Thanks
Steve

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Is G84 supported in Mach3?
« Reply #1 on: October 07, 2009, 06:24:55 PM »
I believe it is but have never used it so dont know how well it works, you will need a floating holder.
Hood
Re: Is G84 supported in Mach3?
« Reply #2 on: October 07, 2009, 07:30:49 PM »
Yes I have used the search function and read all of the posts I found and I have searched the MachMill manual and noticed the G84 section is greyed out.  So my question is Mach capable of rigid tapping if the mill is capable?
Thanks
Steve

I'm pretty sure Mach does NOT do rigid tapping.  It's one of the things pretty high up on the ToDo list for v4.

Regards,
Ray L.
Regards,
Ray L.