Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: srbliss on October 07, 2009, 06:12:17 PM
-
Yes I have used the search function and read all of the posts I found and I have searched the MachMill manual and noticed the G84 section is greyed out. So my question is Mach capable of rigid tapping if the mill is capable?
Thanks
Steve
-
I believe it is but have never used it so dont know how well it works, you will need a floating holder.
Hood
-
Yes I have used the search function and read all of the posts I found and I have searched the MachMill manual and noticed the G84 section is greyed out. So my question is Mach capable of rigid tapping if the mill is capable?
Thanks
Steve
I'm pretty sure Mach does NOT do rigid tapping. It's one of the things pretty high up on the ToDo list for v4.
Regards,
Ray L.