Hello Guest it is April 19, 2024, 10:51:54 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: DRO Speed  (Read 3180 times)

0 Members and 1 Guest are viewing this topic.

Offline Ray

*
  • 70 70
    • View Profile
DRO Speed
« on: October 03, 2009, 04:03:27 PM »
Just put Mach3 on another computer and when jogging, the DRO keeps going after I release the jog button for a second or two.  Where do I fix this please? 
Thanks
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: DRO Speed
« Reply #1 on: October 03, 2009, 04:20:28 PM »
Sounds like your acceleration is set very low. When you release the key Mach decelerates to a stop so if that is slow then it will take a while after the button has been released.
Hood
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: DRO Speed
« Reply #2 on: October 03, 2009, 05:06:35 PM »
Or, you have it set to incremental jog mode and it's jogging a specified distance with each push of the key.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline Ray

*
  • 70 70
    • View Profile
Re: DRO Speed
« Reply #3 on: October 03, 2009, 07:12:53 PM »
Thanks Hood and Ger21.  It was the Acc. and Vel. settings.  I should have taken a pen and paper to the shop and noted the settings on that computer, but instead I relied on my super memory (ha ha).  Glad you both were here.  Thanks again, Ray
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: DRO Speed
« Reply #4 on: October 03, 2009, 07:20:25 PM »
Even easier would have been to copy the xml and paste it to the new computer, that would transfer all your settings :)

Hood
Logged
Pages: 1   Go Up
« previous next »