Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ray on October 03, 2009, 04:03:27 PM
-
Just put Mach3 on another computer and when jogging, the DRO keeps going after I release the jog button for a second or two. Where do I fix this please?
Thanks
-
Sounds like your acceleration is set very low. When you release the key Mach decelerates to a stop so if that is slow then it will take a while after the button has been released.
Hood
-
Or, you have it set to incremental jog mode and it's jogging a specified distance with each push of the key.
-
Thanks Hood and Ger21. It was the Acc. and Vel. settings. I should have taken a pen and paper to the shop and noted the settings on that computer, but instead I relied on my super memory (ha ha). Glad you both were here. Thanks again, Ray
-
Even easier would have been to copy the xml and paste it to the new computer, that would transfer all your settings :)
Hood