Hello Guest it is March 29, 2024, 08:41:50 AM

Author Topic: Current list of G & M Codes for Lathe  (Read 8164 times)

0 Members and 1 Guest are viewing this topic.

Offline Dan13

*
  •  1,208 1,208
    • View Profile
    • DY Engineering
Re: Current list of G & M Codes for Lathe
« Reply #10 on: September 23, 2009, 08:09:01 AM »
Hood,

Ok, they ARE mentioned in the manual, but not under the section you'd expect them to be. They are not in the list (like you you noted) or the gcode section, and only mentioned on page 6-2.

Daniel

Offline Dan13

*
  •  1,208 1,208
    • View Profile
    • DY Engineering
Re: Current list of G & M Codes for Lathe
« Reply #11 on: September 23, 2009, 08:10:48 AM »
Was typing when you posted your reply ;)

Daniel
Re: Current list of G & M Codes for Lathe
« Reply #12 on: September 23, 2009, 08:42:24 AM »
The Using Mach3TURN MANUAL has a listing, and it includes in the listing lists the Gcode ( associated macro ) for G77  ( M1077.MIS ) and G78 ( M10778.MIS ). If it dosen't list it there I'll  assume that it's not supported.
RICH

Hi Rich

Just had a look and couldn't find it


Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Current list of G & M Codes for Lathe
« Reply #13 on: September 23, 2009, 08:46:21 AM »
The Using Mach3TURN MANUAL has a listing, and it includes in the listing lists the Gcode ( associated macro ) for G77  ( M1077.MIS ) and G78 ( M10778.MIS ). If it dosen't list it there I'll  assume that it's not supported.
RICH

Hi Rich

Just had a look and couldn't find it


Phil

Pg 10-10 and 10-17

Hood
Re: Current list of G & M Codes for Lathe
« Reply #14 on: September 23, 2009, 09:08:14 AM »
Sorry i thought it was in the LazyTurn Manual

Where do i find the Mach3TURN MANUAL  ::)

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Current list of G & M Codes for Lathe
« Reply #15 on: September 23, 2009, 09:11:02 AM »
Support link at the top of the page.
Hood

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: Current list of G & M Codes for Lathe
« Reply #16 on: September 23, 2009, 09:39:09 AM »
Sorry, but the LazyTurn manual is still in developement like the software.  :)
RICH