Have not been able to do my 1st cut on an MDF piece (see attached files). The router follows my design but when the program runs the router is raised to about 1” above the surface and then it decent to about 1/8” above the surface and stays there until the program ends.
On the setup / postings Options I have set: Plunge clearance = 0.1000 and line number increment = 5
On the layers menu I have set: Tool = 0.125” diameter, Plunge feed = 0.50”/min, Per pass = 0.1250”, Feed Rate = 15.00”/min, Total number = 0.
On the extends menu I have set:
Min X = 0”, Max X = 8”
Min Y = 0”, Max Y = 11”
Min Z = 0.1250”, Max Z = 1”
Can someone tell me where my mistake is?
Thank you
Nicolas