0 Members and 1 Guest are viewing this topic.
If you set Z=0 to the top of your workpiece, it won't cut anything. All your cuts are at Z=0
Try it using 0.125, NOT -0.125. I think LazyCAM wants a positive number for depth of cut, as it's now cutting .125 above the part.
Quote from: ger21 on September 02, 2009, 06:50:28 PMTry it using 0.125, NOT -0.125. I think LazyCAM wants a positive number for depth of cut, as it's now cutting .125 above the part.I don't use lazyCCAM, but the code you posted is cutting at Z 0.125. The manual says this number should be negative, unless I dont understand somethingNicolas