Hello Guest it is February 06, 2026, 03:01:51 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: DynaTorch THC  (Read 10285 times)

0 Members and 2 Guests are viewing this topic.

Offline fer_mayrl

*
  • *
  • 453 453
DynaTorch THC
« on: August 25, 2006, 12:30:27 AM »
Hello,
Has anyone heard or used the DynaTorch torch height control with Mach 3? Does it work? How does it compare to campbells TCH 300?
here is the link:
http://www.dynatorch.com/avhtctrl.htm

Regards
Fernando
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: DynaTorch THC
« Reply #1 on: August 25, 2006, 10:44:25 AM »
That one is not going to hook into mach3.. other then that it should work???
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline fer_mayrl

*
  • *
  • 453 453
Re: DynaTorch THC
« Reply #2 on: August 25, 2006, 11:05:27 AM »
Any recomendations on Torch height control attachments?
I am a little bit sceptical and uninformed  about the floating head design needed to use campbells THC.

Regards
Fernando
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: DynaTorch THC
« Reply #3 on: August 25, 2006, 11:18:14 AM »
did you look a the one from C&Cnc ...
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline fer_mayrl

*
  • *
  • 453 453
Re: DynaTorch THC
« Reply #4 on: August 25, 2006, 11:23:47 AM »
Hi Brian,
Yes I did, it has more bells and whistles than the one from bob campbell, but it uses the same principle of the floating head. I still dont know entirely how that works.

Will look into it
Thanks
Fernando
Logged
Pages: 1   Go Up
« previous next »