Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fer_mayrl on August 25, 2006, 01:30:27 AM
-
Hello,
Has anyone heard or used the DynaTorch torch height control with Mach 3? Does it work? How does it compare to campbells TCH 300?
here is the link:
http://www.dynatorch.com/avhtctrl.htm
Regards
Fernando
-
That one is not going to hook into mach3.. other then that it should work???
-
Any recomendations on Torch height control attachments?
I am a little bit sceptical and uninformed about the floating head design needed to use campbells THC.
Regards
Fernando
-
did you look a the one from C&Cnc ...
-
Hi Brian,
Yes I did, it has more bells and whistles than the one from bob campbell, but it uses the same principle of the floating head. I still dont know entirely how that works.
Will look into it
Thanks
Fernando