Well getting closer to a cut FINALLY ,, got the belts in wired up waiting on limit switches to install. But cut a lot of air and started getting the servos calibrated using the motor setup on the program run page ,, nice and smooth until i get over 85 to 100 IPM then the 60 inch long ballscrews want to start wobbling a bit but I doubt I do any cutting at over 100 IPM anyway ,, Next time I will use belts or gears for the long axis..Live and learn ..
Hope to actually get a spoil board in and a cut out next week...
Will try to post pictures or video too.
Gary