Hello Guest it is May 24, 2025, 05:45:55 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach3 Lathe Wizards  (Read 9110 times)

0 Members and 1 Guest are viewing this topic.

Offline dgoddard

*
  • 30 30
Mach3 Lathe Wizards
« on: May 11, 2009, 05:57:58 PM »
Just completed my CNC conversion for the Grizzly G0602 lathe and now am starting the learning and fun phase.  I plan to run in the Diameter mode.  My question is:  Do the "Lathe Turning Wizards" by Brian/Kiran output g-code in diameter or radius mode?
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Mach3 Lathe Wizards
« Reply #1 on: May 11, 2009, 06:13:12 PM »
I run Dia mode and the wizards work fine :0
Hood
Logged

Offline dgoddard

*
  • 30 30
Re: Mach3 Lathe Wizards
« Reply #2 on: May 12, 2009, 06:35:13 PM »
Tried a wizard out today and alll worked fine in diameter mode.
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Mach3 Lathe Wizards
« Reply #3 on: May 12, 2009, 06:38:34 PM »
I think the VB in the wizards will actually look to see which mode you are in and output accordingly :)
Hood
Logged
Pages: 1   Go Up
« previous next »