Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dgoddard on May 11, 2009, 05:57:58 PM
-
Just completed my CNC conversion for the Grizzly G0602 lathe and now am starting the learning and fun phase. I plan to run in the Diameter mode. My question is: Do the "Lathe Turning Wizards" by Brian/Kiran output g-code in diameter or radius mode?
-
I run Dia mode and the wizards work fine :0
Hood
-
Tried a wizard out today and alll worked fine in diameter mode.
-
I think the VB in the wizards will actually look to see which mode you are in and output accordingly :)
Hood