Dear All,
Don't know if this is the correct place to post this, but here goes anyway. As I understand it, Mach 3 has a plug-in or driver, I don't know which, to interface to a Galil motion control board or boards. The questions are these:- Is the communication protocol between Mach 3 and the Galil board open to be looked at and studied? I assume that the Galil boards are PCI based? The reason for these questions is that I think Galil products are very expensive and I have seen a PCI motion control board for a fraction of the cost of a Galil, but it will obviously need a new driver or plug-in writing to communicate with Mach 3. I don't know if I'm clever enough to do this either. Any comments and advice gratefully received.
Dave.