I love the Grex/G100, but one thing I have found hard to adjust to is the delay in axis movement when jogging from the keyboard in Mach.
I am wanting to build a pendant with MPG control (encoder wheel), axis select (X, Y, Z, A), and distance set (1, 0.1, 0.01, 0.001).
I am not sure if the current Mach3/4 (Grex firmware?) will support this, since the pendant will be using inputs on the Grex.
I would assume the pendant controls should directly drive the Grex, otherwise if the inputs from the Grex are fed to Mach, which then will try to step the Grex.. I would be back where I started with the delays in jogging axis movement, correct?
Anyone have any information on doing this?
Thanks-
Colin