Hello Guest it is May 11, 2025, 03:51:07 AM
Profile Guest
« previous next »
Pages: « 1 2 3 4   Go Down

Author Topic: How do I remove this out of the gcode  (Read 29881 times)

0 Members and 1 Guest are viewing this topic.

Offline davy182

*
  • 99 99
Re: How do I remove this out of the gcode
« Reply #30 on: August 27, 2008, 11:10:56 PM »
I have gone from 0-.00000001 they only thing that fixes it once it starts opening dxfs like this is to close down lcam and reopen.
Logged

Offline Overloaded

*
  • *
  • 4,923 4,923
Re: How do I remove this out of the gcode
« Reply #31 on: August 27, 2008, 11:15:41 PM »
The entry may need to be LARGER. Looks like you are setting it SMALLER.
Try 1.00000 just for kicks.
Logged

Offline davy182

*
  • 99 99
Re: How do I remove this out of the gcode
« Reply #32 on: August 27, 2008, 11:28:09 PM »
Just tried the 1.0 and didn't work once I get it to start opening the dxfs with the circles reading as two arcs no matter what I do only closing and reopening works
Logged

Offline Overloaded

*
  • *
  • 4,923 4,923
Re: How do I remove this out of the gcode
« Reply #33 on: August 27, 2008, 11:41:04 PM »
Hmmmm...Maybe post your DXF like Chip asked earlier.
Might find something there.
RC
Logged

Offline davy182

*
  • 99 99
Re: How do I remove this out of the gcode
« Reply #34 on: August 28, 2008, 10:48:09 PM »
here is the dxf
Logged

Offline Overloaded

*
  • *
  • 4,923 4,923
Re: How do I remove this out of the gcode
« Reply #35 on: August 28, 2008, 11:21:11 PM »
Davy,
I tried all I could and it works fine here...3.00.2
Strange....hopefully Chip can help.
RC
Logged
Pages: « 1 2 3 4   Go Up
« previous next »