I have been running Mach3 with Dell 800 for 3 months on a 4 axis machine. The X axis stopped working suddenly.
I have checked the LPT port motor output pins for voltage. Y, A, and B look the same. DIR 0-5V, Step 0-50mV. Y, A, and B work. X stopped working. DIR shows 0-5 v Step shows 80mv -130mv at the port pin. DRO moves but no motor movement.
I have verified the X axis wiring and motor are good on the other axis.
I have check the LPT port with a printer and it works.
The strange thing is if I swap the Step and Dir pins in the setup I get good voltage readings. (but my driver board can't use it like that).
Thoughts appreciated.
(I would like to get some sleep.)
Thanks