1
General Mach Discussion / changing mach from inches to run a gcode output in mm
« on: April 15, 2019, 03:09:53 PM »
Hi,
I always run my machine in inches, but now I have some code output from different software that only does mm.
So should i create a new profile and set unit to mm and change motor tuning settings accordingly.
Just figure its easier to just fire up the appropriate profile then...one for inches, one for mm.
thoughts? suggestions...
I always run my machine in inches, but now I have some code output from different software that only does mm.
So should i create a new profile and set unit to mm and change motor tuning settings accordingly.
Just figure its easier to just fire up the appropriate profile then...one for inches, one for mm.
thoughts? suggestions...