Have you done the Reset before trying to Jog off?
Hood

I'm pretty sure I did, but when i tried to do it again this morning, my mouse stopped working and i need to solve that before i can do a double check. don't you ever sleep?

don't you ever sleep?

Yep, some people talk in their sleep, I type

Hood

I can believe it. Re: jogging off limit switch, problem solved. Thanks again, bob

Great
Hood

Hood, I just sent an email to your PM, but then realized that this would be better. Just tried to do the first run w/ my machine, loaded a file, which appeared in the File line, pushed Cycle Start, but nothing happened. I can jog all three axes, the Diagnostics page is clean, there are no error messages, and the Reset button is not blinking. Any suggestions?
Thanx, Bob

Answered your PM, can you attach your code to this thread please.
Hood

see attached. by the "greenish box in the upper left hand corner of the screen', I mean the one where I think Gcode is supposed to be displayed, and it has a horizontal white stripe across the middle of it.

the code loads fine here, can you attach your xml and I will see if I can find a problem there.
Hood

attached