Chip,
School is closed until Monday and I'm out of town. But I'll go in as soon as I get back and try to get some pictures. We don't have much in the way of documentation. How can I tell if the motors are stepper or servo? And when you asked, "In Config, Ports & Pins, Output's Page, No pin's selected. " were you reading our XML?
Hood,
Of course you wouldn't want that manual! I don't know what I was thinking! I was rushing out of town and grabbed the only manual we have. MaxNC didn't provide any documentation. I'll email them right now to see if anything is available.
thanks everyone,
Larry