Hello Guest it is April 16, 2024, 02:29:06 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4 5 6   Go Down

Author Topic: Help getting set up  (Read 21774 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Help getting set up
« Reply #50 on: November 15, 2008, 07:08:18 PM »
OK so  we know Mach is OK, your port is OK, your cable is OK so now check on the output side of the C10 and that will show whether the signals are passing through it. If they are not then double and tripple check it is wired correctly and if still not getting them then the C10 looks suspect.
Hood
Logged

Offline Rob27

*
  • 25 25
    • View Profile
Re: Help getting set up
« Reply #51 on: November 15, 2008, 07:23:27 PM »
When I checked on the cable pins, I can get to the 3 and 25, but with the cable hooked up, I can get to the 3, but where do I get to the 25 pin?
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Help getting set up
« Reply #52 on: November 15, 2008, 07:43:48 PM »
From the common connector beside the pins connector.
Hood
Logged

Offline Rob27

*
  • 25 25
    • View Profile
Re: Help getting set up
« Reply #53 on: November 15, 2008, 07:54:13 PM »
From here I read between 0 and .5v dc, with only the power from the printer cord... With everything on, I get 4.75v dc, going in either direction...
« Last Edit: November 15, 2008, 07:57:06 PM by Rob27 »
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Help getting set up
« Reply #54 on: November 15, 2008, 08:03:21 PM »
Well either your BOB is bad or your wiring is bad. If you still cant get it after checking the wiring your best bet is to contact Arturo and see what he suggests as a test.
Hood
Logged

Offline Rob27

*
  • 25 25
    • View Profile
Re: Help getting set up
« Reply #55 on: November 15, 2008, 10:24:59 PM »
Success!!! All motors are running, and dialed in! A couple of pins on the BOB was the culprit!
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Help getting set up
« Reply #56 on: November 16, 2008, 03:24:43 AM »
Great news :)
Hood

Logged
Pages: « 1 2 3 4 5 6   Go Up
« previous next »