Hi,
So what does that mean. I clicked on the shortcut on the desktop for mach to open, but didn't open it and clicked on properties, thenit has 3 buttons one is general, one is shortcut,and one is capabilities. The tab in general is Mach3Mill, no spaces shortcut,C:\Mach3\Mach3.exe /p Mach3Mill. Capabilities is nothing.I changed in the general tab to MachX2. and it works, close the tab out and close Mach alltogether, start up again, and the 3 are the same, except the wizards do not work. It still says MachX2, Do over again start MachX2,and open program,get ready to run,press wizards,wizards open, cannot do any changes..... Close MachX2, click on MachX2 on desktop,highlight,to properties,and is still General MachX2 shortcut the same, open MachX2,and wizards still do not work, Back to desktop,click properties,same MachX2 change to MachMill close, open Machmill start program, Wizards work. till next shutdown, then have to rename it again to MachX2 to get it to work again. Every other time i shut down Mach,Ihave to rename the general with a different MachX2 or machMill to get the wizards to work. Hope this Helps in Explaining this problem. Thanks, Hank S.