Hello Guest it is April 19, 2024, 08:42:44 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: X Y Position  (Read 3302 times)

0 Members and 1 Guest are viewing this topic.

Offline Al

*
  • 12 12
    • View Profile
X Y Position
« on: November 10, 2008, 02:24:51 PM »
I have drawings referencing center lines, so my drawings are both - and +  X&Y. When I import the dxf into Lazycam the drawing becomes positive X&Y only. Am I missing something in Lazycam (licensed version) to allow it to use and post - & +

Al

Logged
Do it today! Tomorrow is Unknown

Offline Overloaded

*
  • *
  • 4,922 4,922
    • View Profile
Re: X Y Position
« Reply #1 on: November 10, 2008, 03:38:38 PM »
Al,
Under "Setup/Loading Options/Autoclean Setings" on the tool bar, try checking this box.
RC
« Last Edit: November 10, 2008, 03:40:25 PM by Overloaded »
Logged

Offline Al

*
  • 12 12
    • View Profile
Re: X Y Position
« Reply #2 on: November 10, 2008, 03:49:03 PM »
RC
thanks so much...I knew it would be something I overlooked

Al
Logged
Do it today! Tomorrow is Unknown

Offline Overloaded

*
  • *
  • 4,922 4,922
    • View Profile
Re: X Y Position
« Reply #3 on: November 10, 2008, 04:27:19 PM »
No prob Al,
 If you do any turning, keep an eye on the LazyTurn board and pinpoint as many issues as possible for ART.
We're going to try to keep him here through the winter....he's doing great work with LT.
RC
Logged
Pages: 1   Go Up
« previous next »