Welcome
I have problem I can not correct tool Y  cuts out me about thickness of tool  on axis for little and X how I have this to put because I sit already 3 day over this :{{

please give more information about your machine, what kind of drives and motors, breakout etc, the more info you can supply the easier it will be to help you.
Hood

screws ball jump 5 mm prostate engines 200 degrees put on 1/2 driver

with that information your steps per unit should be set to 80, is that what you have?

Hood

I have  put on 80 and it  about thickness of tool is for little still

Are you set in metric units? Try putting G21 in the MDI before you make your move. If that is not working then what exactly are you doing to make your motor move, ie what code and when it stops do you hear any noise from the motor when it stops.

Hood

I have not configured programme  now I  made without schedule of tools and the same goes out that is I do something ¿le from schedule but what ??

sorry dont understand what you are meaning

Hood

I have bad configured  waves tool

sorry still dont understand, hopefully someone else will manage to figure out what you are meaning.
hood