Hello Guest it is January 25, 2025, 03:14:32 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: RhinoCam Mach3 Post Processors  (Read 12655 times)

0 Members and 1 Guest are viewing this topic.

Offline hoop

*
  • 2 2
RhinoCam Mach3 Post Processors
« on: September 12, 2008, 09:30:29 PM »
For those needing the mach3 post processors for RhinoCam, these were given to me directly by MecSoft support.

Hosted here: http://www.mediafire.com/?sharekey=a5a3811cdc5bff98d2db6fb9a8902bda

Both MM and INCH post processors are included.

-Hoop
Logged

Offline DennisF

*
  • 388 388
Re: RhinoCam Mach3 Post Processors
« Reply #1 on: January 03, 2010, 12:35:23 PM »
Hello Hoop
 I would like a copy of the post processors when i clicked on your link it brought a web site called media fire and i couldn't find the post processor any where on the page thanks.

Dennis
Logged

Offline mataf01

*
  • 5 5
Re: RhinoCam Mach3 Post Processors
« Reply #2 on: November 01, 2010, 03:40:56 PM »
hello Hoop,
Same problem for me!
Patrick
Logged
Pages: 1   Go Up
« previous next »