Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: hoop on September 12, 2008, 09:30:29 PM
-
For those needing the mach3 post processors for RhinoCam, these were given to me directly by MecSoft support.
Hosted here: http://www.mediafire.com/?sharekey=a5a3811cdc5bff98d2db6fb9a8902bda
Both MM and INCH post processors are included.
-Hoop
-
Hello Hoop
I would like a copy of the post processors when i clicked on your link it brought a web site called media fire and i couldn't find the post processor any where on the page thanks.
Dennis
-
hello Hoop,
Same problem for me!
Patrick