Just upgraded to V3.041 cuz I was having some issues with the lockdown.
Using a G95 to calculate feedrate from spindle speed. Have an index to get RPM, but spindle is not controlled by Mach, I turn on and off and set the RPM.
Problem is it sets feedrate to COMMANDED instead of ACTUAL spindle speed. If there is no commanded RPM it gives an error of no RPM in G95 mode and rapids thru cut. If I command a RPM, it sets the FR and won't change it if I vary speed. It worked in the lockdown, usually; sometimes it would rapid thru 2 cuts if I had rapided tool away after setup. That's what I'm trying to get away from.
Using the same XML file as the lockdown. What do I need to change so it will use the actual RPM to set feedrate?
Thanks in advance
Mark