Hello Guest it is March 29, 2024, 12:41:54 AM

Author Topic: Installed Mach3 after hard drive failure  (Read 3784 times)

0 Members and 1 Guest are viewing this topic.

Offline CJEls

*
  •  69 69
    • View Profile
Installed Mach3 after hard drive failure
« on: August 10, 2008, 04:47:56 AM »
Hi all

I installed mach on a new hard drive after my origanal drive failed but now I can not get the turret going.I did copy the XLM file to give me the same setup and i did check that all the settings were correct. I use the same Xp  software as before. It seems thet it is not reading the M6 macro. If you call for atool change the dro does change but the turret is not moving.Any suggestions

CJ

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #1 on: August 10, 2008, 07:18:04 AM »
Did you remember to copy over the M6Start.m1s into the correct profile macro folder?

Hood

Offline CJEls

*
  •  69 69
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #2 on: August 10, 2008, 07:44:39 AM »
Hallo Hood

Yes I did.

Cj

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #3 on: August 10, 2008, 08:31:52 AM »
Well if its definitely in the correct profile in the macro folder then it should work. Any more info about the toolchanger? How does it connect ie is it Modbus and PLC or just I/O from the PP or Modbus through ModIO or Arturos stuff?
 Is this a mill or lathe?

Hood

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #4 on: August 10, 2008, 10:11:14 AM »
In General config, top left,  what do you have set as tool change option?

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline CJEls

*
  •  69 69
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #5 on: August 10, 2008, 04:03:07 PM »
Hallo Hood

It is a lathe.I do not know if XP service pack 3 has a problem with the set up. I am re formating the drive and will only load Xp with service pack 2,this is how the previose drive were set up.I hope this will help.

Thanks

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Installed Mach3 after hard drive failure
« Reply #6 on: August 10, 2008, 04:09:14 PM »
Its just SP2 I use but never heard anyone saying SP3 didnt work but heres hoping it cures your probs.
Hood