Hello Guest it is March 29, 2024, 02:53:24 AM

Author Topic: start position  (Read 2418 times)

0 Members and 1 Guest are viewing this topic.

start position
« on: August 04, 2008, 09:42:52 AM »
Is it possible to give my mill a general start position after ref??

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: start position
« Reply #1 on: August 04, 2008, 09:47:40 AM »
Yoiu can set a G28 position on the homing and limits page (from Config tab) you can then either call G28 from the MDI line or you could add a line to your Ref All button to do the G28 after you have referenced your machine.
Hood