Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mkink on August 04, 2008, 09:42:52 AM

Title: start position
Post by: mkink on August 04, 2008, 09:42:52 AM

Is it possible to give my mill a general start position after ref??

Title: Re: start position
Post by: Hood on August 04, 2008, 09:47:40 AM

Yoiu can set a G28 position on the homing and limits page (from Config tab) you can then either call G28 from the MDI line or you could add a line to your Ref All button to do the G28 after you have referenced your machine.
Hood