Hello Guest it is March 28, 2024, 04:36:00 AM

Author Topic: ArtCam  (Read 24453 times)

0 Members and 1 Guest are viewing this topic.

ArtCam
« on: May 31, 2006, 08:43:58 PM »
Hai All, :)

I have set up my router and i am using ArtCam,Could any one help me with how to set up the post processor.

Presently i have set it up as "camtech(inch)"

And till now i did not have any problem.

And i am planning to get s post processor for Mach

It would be very thankful if any one would help me

ynneb

*
Re: ArtCam
« Reply #1 on: June 01, 2006, 12:14:59 AM »
I would ask the Artcam people. I think they have a post processor for mach.
Re: ArtCam
« Reply #2 on: June 01, 2006, 11:55:50 AM »
I think Art cam comes with a mach 2 post processor, if it doesnt use the "G code (inch)" or "G code (mm)" thats how I remember them to appear on the list.
Not sure though, i dont have artcam.
Regards
Fernando

Offline zealous

*
  •  489 489
  • HI!
    • View Profile
    • Artsoft Solutions
Re: ArtCam
« Reply #3 on: June 02, 2006, 04:10:07 AM »
Which vertion of Artcam are you using?
Here you can see that Artcam 8.1 has a post processor for Mach 2 that will work as well with Mach 3.

http://forum.artcam.com/viewtopic.php?t=2331&highlight=mach+3
Re: ArtCam
« Reply #4 on: August 16, 2007, 08:11:42 AM »
I use the mach2 MM post processor for 3 axis stuff and I use the modelmaster 4 axis post processor for rotary work.  So far both seem to work well with mach3