Machsupport Forum
Support => Downloads => Post Processors => Topic started by: antony_vm on May 31, 2006, 08:43:58 PM
-
Hai All, :)
I have set up my router and i am using ArtCam,Could any one help me with how to set up the post processor.
Presently i have set it up as "camtech(inch)"
And till now i did not have any problem.
And i am planning to get s post processor for Mach
It would be very thankful if any one would help me
-
I would ask the Artcam people. I think they have a post processor for mach.
-
I think Art cam comes with a mach 2 post processor, if it doesnt use the "G code (inch)" or "G code (mm)" thats how I remember them to appear on the list.
Not sure though, i dont have artcam.
Regards
Fernando
-
Which vertion of Artcam are you using?
Here you can see that Artcam 8.1 has a post processor for Mach 2 that will work as well with Mach 3.
http://forum.artcam.com/viewtopic.php?t=2331&highlight=mach+3
-
I use the mach2 MM post processor for 3 axis stuff and I use the modelmaster 4 axis post processor for rotary work. So far both seem to work well with mach3