Recently my ASUS motherboard decided to start acting up and I had to replace the motherboard with a new one. The system would just restart at any point. I setup the new system on a new Harddrive because the old motherboard is still on warrenty and will be replaced so I didn't want to format the old drive. Anyhow I reinstalled the latest version of Mach on the new drive. I am using the C11 multifunction breakout board from CNC4PC. The guy who did the retrofit for me, said if ever I had to replace the computer, all I had to do was Copy the mach3mill.XML file and all my parameters would remain the same. He's on vacation right now so I can't ask him. After overwriting the stock XML file, the parameters that I remembered are still there even my last fixture ofset is correct. The Problem is I can't get it off ESTOP. It says external ESTOP requested. There is a check mark on the active low input and I tried to toggle it but it still didn't make any difference. Do you guys have any idea what could be causing this issue?
Thanks
Dan