Hello Guest it is November 08, 2024, 08:49:31 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: How do I change the z-Axel in Mach3.....  (Read 5692 times)

0 Members and 1 Guest are viewing this topic.

Offline Mikkef

*
  • 3 3
How do I change the z-Axel in Mach3.....
« on: July 01, 2008, 05:20:29 AM »
Hi,
I have Mach3 ver 3.41 and I need to know wher In the setup I can change the Z - axel.
In the G-code it's G-1.0000 and my Z axel go upp and this is wrong...

I whant to change so the Z-axel go down with G-1.0000...  ???and up with G1.0000

Please let me know how I do this... Thank's

Regards
Mikael
Logged

Offline Overloaded

*
  • *
  • 4,922 4,922
Re: How do I change the z-Axel in Mach3.....
« Reply #1 on: July 01, 2008, 08:23:32 AM »
Top tool bar,
Config
Ports and Pins,
Motor Outputs,
Dir. Low Active.   Put a green check mark in there and try it again.
RC
Logged
Pages: 1   Go Up
« previous next »