Machsupport Forum
Mach Discussion => FAQs => Topic started by: Mikkef on July 01, 2008, 05:20:29 AM
-
Hi,
I have Mach3 ver 3.41 and I need to know wher In the setup I can change the Z - axel.
In the G-code it's G-1.0000 and my Z axel go upp and this is wrong...
I whant to change so the Z-axel go down with G-1.0000... ???and up with G1.0000
Please let me know how I do this... Thank's
Regards
Mikael
-
Top tool bar,
Config
Ports and Pins,
Motor Outputs,
Dir. Low Active. Put a green check mark in there and try it again.
RC