I have exhausted all avenues to get my motors running.  Have been working with Mach3 support and they have the software correct.  But only my z axis responds to key strokes.  The others take off when I reset the gecko. 
I need on site help and will pay for the service
I live in southwest Pa. in a town called Belle Vernon.

Pat Herforth

My address is:
538 Main St.
Belle Vernon, Pa. 15012
724 929-9834


Help!!!!!!!!!!!!!!!

Hi, Pat

If there servos, It most likely you need to reverse the A B pins on your encoder inputs or reverse the servo  motor polarity.

Thanks, Chip