Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: PCH on June 25, 2008, 08:15:24 PM
-
I have exhausted all avenues to get my motors running. Have been working with Mach3 support and they have the software correct. But only my z axis responds to key strokes. The others take off when I reset the gecko.
I need on site help and will pay for the service
I live in southwest Pa. in a town called Belle Vernon.
Pat Herforth
My address is:
538 Main St.
Belle Vernon, Pa. 15012
724 929-9834
Help!!!!!!!!!!!!!!!
-
Hi, Pat
If there servos, It most likely you need to reverse the A B pins on your encoder inputs or reverse the servo motor polarity.
Thanks, Chip