I thought the enable2 problem may be because of the MaxNC NC Mode, but when I turn MaxNC Mode off and restart the program the enable LEDs still do not function for enable signals 2 and up. So its not the MaxNC mode but something to do with the MachTurn profile itself.
I have managed to get the axis working and the Spindle speed and Spindle reverse. The only problem I have now is I can not figure out how to get the encoder working on the spindle. When I run the spindle there is no output waveforms from the lathe controller on any of the pins 2 through 4 like I thought there would be.
Its getting close though.
Shawn