Hello Guest it is March 28, 2024, 07:13:14 AM

Author Topic: No tabs  (Read 7799 times)

0 Members and 1 Guest are viewing this topic.

Re: No tabs
« Reply #10 on: May 26, 2008, 08:14:24 AM »
Then, tabs in LC and the results in Mach3.

Re: No tabs
« Reply #11 on: May 26, 2008, 12:14:22 PM »
It may be something about a beta product or may be my lack of understanding... is this a lead in issue..  What is a lead in?

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: No tabs
« Reply #12 on: May 26, 2008, 03:44:07 PM »
Hi, CurtisU

What ver. of LCam are you using, 3.00.2 hear, Posts the code fine with or without LC Lic.

Look under Help about in LC to see.

Thanks, Chip
Re: No tabs
« Reply #13 on: May 27, 2008, 07:55:29 PM »
Figured it out....    I was getting the sawtooth tab action when my connection tolerance was to large, 0.125" in my case, depth per pass on that tool  was set for 0.125", might be a correlation there.

LC version 3.00.2 here too.

That comment in one of the videos about having a look at the connection tolerance if you get strange postings had always been on my mind, I thought I'd already explored that avenue, oh well.

Until next time,
Curtis

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: No tabs
« Reply #14 on: May 27, 2008, 09:42:18 PM »
Hi, CurtisU

Glad you got it sorted out.

Thanks, Chip
Re: No tabs
« Reply #15 on: May 28, 2008, 03:07:34 AM »
Hi Curtisu

If I may asc, did you use offsets in your project?

Greetsings:
Willem
Re: No tabs
« Reply #16 on: May 29, 2008, 06:24:31 PM »
Hello Willem,

Neither this example or the project I was trying to get coded were offsets, they were intended to be coded direct from the .dxf.

Curtis