Hello Guest it is June 19, 2019, 11:40:54 AM

Author Topic: saving work offsets  (Read 2555 times)

0 Members and 1 Guest are viewing this topic.

Offline birdbrain

*
  •  41 41
  • Stupidity, beyond belief!
    • View Profile
saving work offsets
« on: May 14, 2008, 05:28:56 PM »
Every time I start Mach3 I have to re-enter all the work and tool offsets. I put them into Mach3 with the G10 command and can use them untill I re-start Mach3. When shutting Mach3 down I always get asked if I want to save the settings, I click to save.
I'm using WinXP original version (no service packs).
Can anyone tell me how to me how to make Mach3 remember all the offsets?

Offline jimpinder

*
  •  1,233 1,233
  • Wakefield, West Yorks, UK
    • View Profile
Re: saving work offsets
« Reply #1 on: May 15, 2008, 02:10:19 AM »
Have a look at Config/General Config - botton left hand corner -

Is persistant offsets ticked - if not, tick the box and try again.
Not me driving the engine - I'm better looking.

Offline birdbrain

*
  •  41 41
  • Stupidity, beyond belief!
    • View Profile
Re: saving work offsets
« Reply #2 on: May 15, 2008, 02:29:26 AM »
Have a look at Config/General Config - botton left hand corner -

Is persistant offsets ticked - if not, tick the box and try again.

Thanks, but it's already checked!

Offline wil

*
  •  28 28
    • View Profile
Re: saving work offsets
« Reply #3 on: May 15, 2008, 04:21:28 AM »
Uncheck the `Copy G54 from G59.253 on startup` Box.
This worked for me tho I`m not sure what the G59.253 is for.

Offline birdbrain

*
  •  41 41
  • Stupidity, beyond belief!
    • View Profile
Re: saving work offsets
« Reply #4 on: May 15, 2008, 06:44:17 AM »
Uncheck the `Copy G54 from G59.253 on startup` Box.
This worked for me tho I`m not sure what the G59.253 is for.

Wow. Thanks. That saves me a lot of time!