Hello Guest it is March 28, 2024, 01:06:13 PM

Author Topic: I/O  (Read 2589 times)

0 Members and 1 Guest are viewing this topic.

I/O
« on: May 17, 2006, 09:55:16 AM »
is it possible to use mach3 with something else than the parralel port? like these 96 I/O card that are available with breakout board and analog outputs.
Re: I/O
« Reply #1 on: May 17, 2006, 10:01:43 PM »
The only other thing is the G100 from GeckoDrive.com . This is run by Mach4 and should be released in a few months...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com