Hello Guest it is January 25, 2025, 04:52:57 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: I/O  (Read 7755 times)

0 Members and 1 Guest are viewing this topic.

Offline tubular2000

*
  • 62 62
I/O
« on: May 17, 2006, 09:55:16 AM »
is it possible to use mach3 with something else than the parralel port? like these 96 I/O card that are available with breakout board and analog outputs.
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: I/O
« Reply #1 on: May 17, 2006, 10:01:43 PM »
The only other thing is the G100 from GeckoDrive.com . This is run by Mach4 and should be released in a few months...
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »