What are my options with your product?
While I am not familiar with your machine, so long as the stepper/servo drives are step/direction controlled then Mach 3 will control your machine.
If the steppers/servos are not controlled this way, you may need to put new drive cards on.
Mach will then allow you to either use its onboard wizards or conversationa options, or run any Gcode that your CAM software can produce.
Essentially, Mach3 will open up as many options as you will ever need.
There is very little it cant do. Infact Mach willl turn an otherwise redundant machine into a diverse machine that can even do 3D milling.
Is this what you were asking?